MPO OM4 Patch Cord

GEZHI offers P grade OM4 MPO fiber optic patch cords.Its comes with multimode fiber appliies to high density in data center or telecommunication systems.

APPLICATION
Data Center
40GbE & 100GbE protocol
Storage area networking
Optical System Access network

Specification

Features

• Laser-Optimized multimode OM4 fiber

• Factory-terminated provide consistent quality, high performance and reduce installation time
• 100% tested for low insertion loss performance and high back reflection
• Optimized performance – available in elite MTP and discrete premium connector upon request

1. Custom Fiber Count

8 Fibers used for 40G/100G QSFP+/QSFP28 direct connection.	12-144 Fibers used for 10G/40G/100G high-denisty structural fiber cabling.

2. Custom Polarity

To properly send data over fiber cable, a link’s transmit signal (Tx) at one end of the cable must match the corresponding receiver (Rx) at the other end. And the role of polarity, which defines the direction that the signal travels, is to make sure that this correspondence is maintained. Fiber polarity is one area that seems to cause a lot of confusion in our industry – especially when it comes to multifiber MPO solutions used in parallel optic applications.

MPO connectors also include a key on the top side of the connector and a white dot on the side to indicate the location of Position 1. The orientation of the key is critical when it comes to polarity.

There are also three different types of MPO cables – Type A, Type B and Type C as below pictures:

OM4 MPO patch cord.jpg

3. Custom Connector

The MPO interfaces on active equipment are male (with pins), and to avoid damage to the transceiver, MPO patch cords should be female (without pins).

Male (with pins)

The male connector is mated to the female side for adapters, cassettes or panels connection.

Female (without pins)

The female connector can be directly connected to transceivers or other male connectors.

未命�?-1.jpg

Specifications

Performance Level			Standard		Elite
Connector	Mode	Endface	IL(max) (dB)	RL(min) (dB)	IL(max) (dB)	RL(min) (dB)
MPO/MTP	MM OM4	8F/APC	≤0.50	≥20	≤0.35	≥20
		12F/APC	≤0.50	≥20	≤0.35	≥20
		24F/APC	≤0.50	≥20	≤0.35	≥20
		8F/PC	≤0.50	≥20	≤0.35	≥20
		12F/PC	≤0.50	≥20	≤0.35	≥20
		24F/PC	≤0.50	≥20	≤0.35	≥20

Odering Information

Type	Mode	Fiber Count	Polarity	Grad	Connector A	Connector B	Polishing	Length
PCMPO	2=OS2 3=OM3 4=OM4 5=OM5	08=8 Fibers 12=12 Fibers 24=24 Fibers 36=3x12 Fibers 48=4x12 Fibers 96=8x12 Fibers 144=12x12 Fibers	A=Type A B=Type B C=Type C	S=Standard E=Elite	M=Male F=Female	M=Male F=Female	P=UPC A=APC	01=1M 02=2M 05=5M 10=10M S=Specify

Download

MPO OM4 Patch Cord.pdf

Inquiry

- verification code

MPO OM4 Patch Cord

verification code

verification code