MPO OS2 Patch Cord

GEZHI Photonics is a factory of pre-terminated 9/125 OS2 Single Mode MPO trunk cable, which offers the user the advantage of consistent quality, much faster installation, and simpler cable management. The MPO fiber optic trunk cable is suitable for use in 40G QSFP+ transceiver, 100G QSFP28, 400G OSFP, 400G QSFP parallel transceiver optics connection. Each MPO OS2 fiber cable has passed the test of Insertion Loss & Return Loss,End-face Inspection, and Polarity Check in the factory, ensuring complies and exceeds industry standards.

1. Custom Fiber Count

2. Custom Polarity

To properly send data over fiber cable, a link’s transmit signal (Tx) at one end of the cable must match the corresponding receiver (Rx) at the other end. And the role of polarity, which defines the direction that the signal travels, is to make sure that this correspondence is maintained. Fiber polarity is one area that seems to cause a lot of confusion in our industry – especially when it comes to multifiber MPO solutions used in parallel optic applications.

MPO connectors also include a key on the top side of the connector and a white dot on the side to indicate the location of Position 1. The orientation of the key is critical when it comes to polarity.

There are also three different types of MPO cables – Type A, Type B and Type C as below pictures:

3. Custom Connectors

The MPO interfaces on active equipment are male (with pins), and to avoid damage to the transceiver, MPO patch cords should be female (without pins). 

Specifications

Odering Information